Lincoln Nautilus: Changing a Road Wheel / Wheel Nuts
WARNING: When you install a wheel, always remove any corrosion, dirt or foreign materials present on the mounting surfaces of the wheel or the surface of the wheel hub, brake drum or brake disc that contacts the wheel. Make sure to secure any fasteners that attach the rotor to the hub so they do not interfere with the mounting surfaces of the wheel. Installing wheels without correct metal-to-metal contact at the wheel mounting surfaces can cause the wheel nuts to loosen and the wheel to come off while your vehicle is in motion, resulting in loss of vehicle control, personal injury or death.
₁ Torque specifications are for nut and bolt threads free of dirt and rust. Use only our recommended replacement wheel nuts and or wheel bolts.
Retighten the wheel nuts to the specified torque within 100 mi (160 km) after any wheel disturbance, such as tire rotation, changing a flat tire or wheel removal.
- Hub pilot bore.
Inspect the wheel pilot hole and mounting surface prior to installation. Remove any visible corrosion or loose particles.
Changing a Flat Tire
WARNING: If the tire pressure
monitor sensor becomes damaged it may
not function.
Note: The use of tire sealant may damage
your tire pressure monitoring system and
should only be used in roadside
emergencies...
Other information:
Lincoln Nautilus 2018-2026 Owners Manual: Child Safety Locks
WARNING: You cannot open the rear doors from inside if you have put the child safety locks on. A child safety lock is on the rear edge of each rear door. You must switch the child safety lock separately on each door. Left-Hand Side Turn the key counterclockwise to switch the child lock off and clockwise to switch it on. Right-Hand Side Turn the key clockwise to switch the child lock off and..
Lincoln Nautilus 2018-2026 Service Manual: Tire Pressure Monitoring System (TPMS) Sensor Location Calibration. General Procedures
Special Tool(s) / General Equipment 204-D081A (204-D081) Tire Pressure Monitor (TPMS) Ford Diagnostic Equipment Programming NOTE: The TPMS can be placed into learn mode using a diagnostic scan tool or manually where a diagnostic scan tool is not available. NOTE: The horn will sound once and the TPMS indicator will flash if the training mode has been entered successful..
Categories
- Manuals Home
- 1st Generation Nautilus Owners Manual
- 1st Generation Nautilus Service Manual
- Locating the Pre-Collision Assist Sensors
- Replacing the Rear Wiper Blades
- Opening and Closing the Hood
- New on site
- Most important about car
Locating the Pre-Collision Assist Sensors
If a message regarding a blocked sensor or camera appears in the information display, something is obstructing the radar signals or camera images. The radar sensor is behind the fascia cover in the center of the lower grille. With a blocked sensor or camera, the system may not function, or performance may reduce. See Pre-Collision Assist – Information Messages.
