Lincoln Nautilus: Charging System - General Information / Charging System - 2.0L EcoBoost (184kW/250PS) – MI4 - Overview. Description and Operation
Overview
The generator is driven by the FEAD belt. When the engine is started, the generator begins to generate AC voltage which is internally converted to DC voltage. The DC voltage is controlled by the voltage regulator and supplied to the battery. The PCM controls the voltage regulator set point, communicating with the generator internal voltage regulator over a dedicated LIN communication circuit.
This vehicle is equipped with load shed strategy. The BCM monitors the battery state of charge and condition using the battery monitoring sensor attached to the negative battery post and manages battery charging.
Charging System - 2.0L EcoBoost (184kW/250PS) – MI4 - System Operation and Component Description. Description and Operation
System Operation
System Diagram
Item
Description
1
MS-CAN
2
HS-CAN
3
LIN
4
LIN
5
PCM
6
BCM
7
IPC
8
Generator
9
Battery monitoring sensor
10
ABS
Network Message Chart
Module Network Input Messages — Body Control Module (BCM)
Broadcast Me..
Other information:
Lincoln Nautilus 2018-2026 Service Manual: Piston Inspection. General Procedures
Inspection NOTE: Do not use a caustic cleaning solution or a wire brush to clean the pistons or damage can occur. Clean and inspect the (1) ring lands, (2) pin bosses, (3) skirts and the (4) tops of the pistons. If wear marks, scores or glazing is found on the piston skirt, check for a bent or twisted connecting rod. NOTE: Make sure the oil ring hol..
Lincoln Nautilus 2018-2026 Service Manual: Blind Spot Information System - Overview. Description and Operation
Overview BLIS ® The BLIS ® aids the driver in assessing whether another vehicle is present within a specific area (blind spot) to either side of the vehicle, extending rearward approximately 6 m (20 ft) beyond the rear bumper while driving on roads and highways. The system is not designed to prevent contact with other vehicles or objects. The BLIS ® uses the exterior mirror BLIS ®/..
Categories
- Manuals Home
- 1st Generation Nautilus Owners Manual
- 1st Generation Nautilus Service Manual
- Opening the Liftgate
- Engine Oil Capacity and Specification - 2.0L
- Folding the Exterior Mirrors - Vehicles With: Manual Folding Mirrors. Folding the Exterior Mirrors - Vehicles With: Power Folding Mirrors
- New on site
- Most important about car
Changing a Flat Tire
WARNING: If the tire pressure monitor sensor becomes damaged it may not function.
Note: The use of tire sealant may damage your tire pressure monitoring system and should only be used in roadside emergencies. If you must use a sealant, use the Tire Mobility Kit sealant. Replace the tire pressure monitoring system sensor and valve stem on the wheel by an authorized dealer after use of the sealant.
Note: The tire pressure monitoring system indicator light will illuminate when the spare tire is in use. To restore the full function of the monitoring system, all road wheels equipped with tire pressure monitoring sensors must be mounted on the vehicle.
If you get a flat tire while driving, do not apply the brake hea
