Lincoln Nautilus: Engine System - General Information / Exhaust Manifold Cleaning and Inspection. General Procedures
Special Tool(s) / General Equipment
| Feeler Gauge |
Cleaning
-
Clean the exhaust manifold using a suitable solvent. Use
a plastic scraping tool to clean the gasket sealing surfaces.
Inspection
-
NOTE: New exhaust manifold gaskets, studs, nuts and/or bolts must be installed when an exhaust manifold is serviced.
NOTE: Use a Straightedge that is calibrated by the manufacturer to be flat within 0.005 mm (0.0002 in) per running foot of length, such as Snap-On® GA438A or equivalent. For example, if the Straightedge is 61 cm (24 in) long, the machined edge must be flat within 0.010 mm (0.0004 in) from end to end.
Using the Straightedge and a Feeler Gauge Set, check the exhaust manifold sealing surface for warpage. If the warpage is greater than 0.76 mm (0.0299 in), install a new exhaust manifold.
Use the General Equipment: Feeler Gauge
 |
Engine Noise Identification and Location. General Procedures
NOTE:
This procedure uses multiple tools/methods to help locate the
source of engine noise. It may be necessary to repeatedly compare the
sound between the tools/methods to help locate the source of the noise...
Intake Manifold Vacuum Test - Gasoline. General Procedures
Bring the engine to normal operating temperature. Connect
the Vacuum/Pressure Tester to the intake manifold. Run the engine at the
specified idle speed...
Other information:
Lincoln Nautilus 2018-2023 Service Manual: Rear Brake Flexible Hose. Removal and Installation
Removal NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water. NOTE: Removal steps in this procedure may contain installation details...
Lincoln Nautilus 2018-2023 Owners Manual: Autowipers
What Are Autowipers Autowipers turns on and controls the speed and frequency of the windshield wipers. Autowipers Settings Using the instrument cluster controls on the steering wheel, select Settings. Select Vehicle. Select Wipers. Switch Rain Sensing on or off...
Categories
- Manuals Home
- 1st Generation Nautilus Owners Manual
- 1st Generation Nautilus Service Manual
- Opening and Closing the Hood
- Engine Oil Capacity and Specification - 2.0L
- Auto-Start-Stop
- New on site
- Most important about car
Traction Control
How Does Traction Control Work
If your vehicle begins to slide, the system applies the brakes to individual wheels and, when needed, reduces power at the same time. If the wheels spin when accelerating on slippery or loose surfaces, the system reduces power in order to increase traction.
Switching Traction Control On and Off
WARNING: The stability and traction control light illuminates steadily if the system detects a failure. Make sure you did not manually disable the traction control system using the information display controls or the switch. If the stability control and traction control light is still illuminating steadily, have the system serviced by an authorized dealer immediately. Operating your vehicle with the traction co
