Other information:
Check
NOTE:
Perform the following pre-checks to make sure module programming completes without errors.
Start the programming session in Key OFF, Engine OFF and prior to initiating programming, turn to KOEO .
Make sure the vehicle battery is fully charged or is
connected to a battery charger. The battery state of charge should be
12.6 - 13.6 volts during vehicle programming.
..
Repair
NOTE:
If the seatbelt webbing does not extract from the seatbelt
retractor from the stowed position, this may be due to a normal
condition which happens when the seatbelt retracts at a high rate of
speed. Follow these steps to release the seatbelt.
Front row seatbelt retractor
NOTE:
Typical front outboard seatbelt retractor shown, other configurations similar.
NOTE:
To un..