Lincoln Nautilus: Maintenance / Exterior Bulbs
Exterior Bulb Specification Chart


Note: LED lamps are not serviceable. See an authorized dealer if they
fail.
Removing a Headlamp Assembly
- Open the hood. See Opening and
Closing the Hood.

- Remove the screws.
- Pull the headlamp toward the front of the
vehicle to disengage it from the lower
fixing point.
- Lift the headlamp up and remove it.

- Disconnect the electrical connector.
Changing a Front Turn Signal Lamp Bulb

- Headlamp low beam.
Headlamp low and high beam -
vehicles with high-intensity
discharge headlamps.
- Headlamp high beam.
Daytime running lamp.
- Front turn signal lamp.
- Remove the headlamp assembly. See
Removing a Headlamp Assembly.
- Turn the bulb holder counterclockwise
and remove it.
- Remove the bulb by pulling it straight out.
Changing a License Plate Lamp Bulb

- Use a suitable tool, for example a
screwdriver, to carefully remove the
lamp.
- Remove the lamp.
- Turn the bulb holder counterclockwise
and remove it.
- Remove the bulb by pulling it straight out.
Vertical Aim Adjustment
The headlamps on your vehicle are properly
aimed at the assembly plant. If your vehicle
has been involved in a crash, have the aim
of the headlamp beam checked by an
authorized dealer...
Interior Bulb Specification Chart
Note: LED lamps are not serviceable. See an authorized dealer if they
fail...
Other information:
Disconnect
NOTICE:
Removing the negative battery ground cable at the LH
strut tower will not disable the vehicle's electrical system. Failure
to disconnect the battery cable from the battery post may cause
component damage.
NOTE:
When the battery is disconnected and connected, some
abnormal drive symptoms may occur while the vehicle relearns its
adaptive strategy. The vehicle may need..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
This step is only necessary when installing a new component.
NOTE:
The PMI process must begin with the current SCCM installed. If the
current SCCM does not respond to the diagnostic scan tool, the tool may
prompt for As-Built Data as part of the repair.
Using a diagnostic scan tool, begin..