Lincoln Nautilus: Wipers and Washers / Wipers and Washers – Troubleshooting
Wipers and Washers – Warning Lamps
Illuminates when the windshield
washer fluid is low.
Wipers and Washers – Frequently Asked Questions
Why are there streaks and smears on the
windshield?
The wiper blades could be dirty, worn
or damaged. Check the wiper blades.
See Checking the Wiper Blades. If the wiper blades are dirty, clean
them with washer fluid or water applied
with a soft sponge or cloth. If the wiper
blades are worn or damaged, install new
ones. See Replacing the Front Wiper
Blades.
Washer Precautions
WARNING: If you operate your
vehicle in temperatures below 41°F (5°C),
use washer fluid with antifreeze protection.
Failure to use washer fluid with antifreeze
protection in cold weather could result in
impaired windshield vision and increase
the risk of injury or accident...
Other information:
Removal
NOTE:
This step is only necessary if the IPMB is being replaced.
NOTE:
This procedure can be used for all locations of the component.
Using a diagnostic scan tool, begin the PMI process for the IPMB following the on-screen instructions.
Position the front driver seat to access the IPMB .
Remove the retainers and the IPMB cove..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Remove the wheel and tire.
Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
Remove the screws.
Torque:
13 lb.in (1.5 Nm)
Remove the front fender moulding.
Refer to: Front Fender Mou..