Lincoln Nautilus: Accessory Charging / Wireless Accessory Charging Module (WACM) - Overview. Description and Operation
The WACM is a 5 Watt wireless power transmitter certified under the Wireless Power Consortium's Qi (pronounced “Chee") Standard. The WACM can be used to energize the secondary receiver coil equipped in one Qi compatible device (smart phone, wireless earbuds case, etc.) thereby charging the device wirelessly. A list of Qi compatible devices can be found on the WPCs website: https://www.wirelesspowerconsortium.com/products.
The WACM is a powered at all time node from fused battery and performs network management on HS-CAN3 . Wireless charging status is provided as a CAN signal on the HS-CAN3 .
The BCM provides a protected switch to battery input to the WACM when an interior passive key search is in progress to disable the wireless charging feature. This is to prevent possible interference with the passive key when placed in close proximity to the WACM during the charge session of a secondary device. A redundant CAN signal is also sent by the BCM in addition to the protected switch to battery input.
Wireless Accessory Charging Module (WACM) - System Operation and Component Description. Description and Operation
System Operation
System Diagram
E344249
*.sttxt {
visibility: hidden;
}
*.stcallout {
visibility: visible;
}
1
GWM
2
BCM
3
APIM
4
ACM
5
WACM
Item
Description
1
GWM
2
BCM
3
APIM..
Other information:
Lincoln Nautilus 2018-2026 Service Manual: Module Configuration - System Operation and Component Description. Description and Operation
System Operation Overview Over the Air (OTA) Programming Over-the-Air updates allow for vehicle system software to be updated wirelessly over Wi-Fi (both private and or public Wi-Fi connection) and or the vehicle cellular network. Over-the-Air updates occur on a rolling basis. By default, the vehicle starts the update process as soon as new software becomes available, notifications of..
Lincoln Nautilus 2018-2026 Service Manual: Side Obstacle Detection Control Module (SODCM). Removal and Installation
Removal Side obstacle detection control module NOTE: This step is only necessary if the SODL or SODR is being replaced. NOTE: LH side is shown, RH side is similar. Using a diagnostic scan tool, begin the PMI process for the SODL or SODR following the on-screen instructions. Remove the rear bumper cover. Refer to: Rear Bumper Cover (501-19 Bumpers) . ..
Categories
- Manuals Home
- 1st Generation Nautilus Owners Manual
- 1st Generation Nautilus Service Manual
- Power Outlet - Vehicles With: 110V Power Outlet
- Auto Hold
- Replacing the Rear Wiper Blades
- New on site
- Most important about car
Clearing the Garage Door Opener. Reprogramming the Garage Door Opener. Garage Door Opener Radio Frequencies
Clearing the Garage Door Opener
