Lincoln Nautilus Manuals

Lincoln Nautilus: Collision Warning and Collision Avoidance System / Collision Warning and Collision Avoidance System. Diagnosis and Testing

Lincoln Nautilus 2018-2025 Service Manual / Electrical / Electronic Feature Group / Collision Warning and Collision Avoidance System / Collision Warning and Collision Avoidance System. Diagnosis and Testing

Symptom Chart

Symptom Chart: Forward Collision Warning

Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices.
REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).


  Symptom Chart


Condition Possible Sources Actions
The forward collision warning system is inoperative   IPMA  
REFER to: Cruise Control (419-03B Cruise Control - Vehicles With: Adaptive Cruise Control With Lane Centering, Diagnosis and Testing).
Pre-collision assist not available sensor blocked   IPMA  
REFER to: Lane Keeping System (419-07 Lane Keeping System, Diagnosis and Testing).
Forward collision warning message request   IPMA  
REFER to: Lane Keeping System (419-07 Lane Keeping System, Diagnosis and Testing).
Too many forward collision warning events occur A MyKey® restricted key is in use VERIFY a MyKey® restricted key is in use. With an administration key, VERIFY forward collision warning system normal operation.

    Collision Warning and Collision Avoidance System - System Operation and Component Description. Description and Operation

    S..

    Side and Rear Vision

    ..

    Other information:

    Lincoln Nautilus 2018-2025 Service Manual: Condenser - 2.0L EcoBoost (184kW/250PS) – MI4. Removal and Installation


    Removal NOTE: Removal steps in this procedure may contain installation details. Remove the cooling module. Refer to: Cooling Module (303-03A Engine Cooling - 2.0L EcoBoost (184kW/250PS) – MI4, Removal and Installation). Remove the cooling module seals. Release the clamps and remove the transmission cooler lines. Torque: 53 lb.in (..

    Lincoln Nautilus 2018-2025 Service Manual: Hydraulic Control Unit (HCU). Removal and Installation


    Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: The HCU and ABS module are released individually. A new HCU does not come equipped with an ABS module. Remove the battery tray. If equipped. Remove the nut, bolt and the battery tray support bracket. Torque: 18 lb.ft (24 Nm) Disconnect the A..

    Categories

    Auto-Start-Stop

    What Is Auto-Start-Stop

    The system is designed to help reduce fuel consumption and CO2 emissions by stopping the engine when it is idling, for example at traffic lights.

    Auto-Start-Stop Precautions

    WARNING: Apply the parking brake, shift into park (P), switch the ignition off and remove the key before you leave your vehicle. Failure to follow this instruction could result in personal injury or death.

    WARNING: Apply the parking brake, shift into park (P), switch the ignition off and remove the key before you open the hood or have any service or repair work completed. If you do not switch the ignition off, the engine could restart at any time. Failure to follow this instruction could result in personal injury or d

    read more

    Copyright © 2025 www.linautilus.com