Lincoln Nautilus: Voltage Converter/Inverter / Direct Current/Alternating Current (DC/AC) Inverter - Component Location. Description and Operation
| Item |
Description |
| 1 |
Alternating Current (AC) Power Outlet Socket |
| 2 |
Direct Current/Alternating Current (DC/AC) Inverter |
Overview
The direct current/alternating current (DC/AC) inverter converts 12
volts DC to 110 volts AC to power AC devices rated 150 watts or less...
Other information:
Removal
NOTE:
LH side shown, RH side similar.
Remove the front door latch.
Refer to: Front Door Latch (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation).
NOTE:
This step is only necessary when installing a new component.
Remove the exterior front door handle reinforcement.
Tighten the screw to release the front exterior handle actuat..
Using the High Beam Headlamps
Push the lever away from you to
switch the high beam on.
Push the lever forward again or pull the lever
toward you to switch the high beams off.
Slightly pull the lever toward you and release
it to flash the headlamps.
Switching Headlamp Exit Delay On and Off
To switch headlamp exit delay on, pull the
turn signal lever toward you after switching
your vehicle of..
Categories
How Does Traction Control Work
If your vehicle begins to slide, the system
applies the brakes to individual wheels and,
when needed, reduces power at the same
time. If the wheels spin when accelerating
on slippery or loose surfaces, the system
reduces power in order to increase traction.
Switching Traction Control On and Off
WARNING: The stability and traction
control light illuminates steadily if the
system detects a failure. Make sure you
did not manually disable the traction
control system using the information
display controls or the switch. If the stability
control and traction control light is still
illuminating steadily, have the system
serviced by an authorized dealer
immediately. Operating your vehicle with
the traction co
read more