Lincoln Nautilus: Uni-Body, Subframe and Mounting System / Frame Assembly - Overview. Description and Operation
Overview
The front subframe is bolted to the body and is used to:
-
aid in structural support.
-
provide mounting surfaces for the steering gear.
-
provide mounting surfaces for the front suspension lower
control arms, the transmission roll restrictor and for the front
stabilizer bar.
The rear subframe is bolted to the body and is used to:
-
aid in structural support.
-
provide mounting surfaces for the rear suspension lower arms and upper arms.
For body dimension specifications,
Refer to: Specifications (501-25 Body Repairs - General Information, Specifications).
Special Tool(s) /
General Equipment
014-3KLIFTTABLEPowertrain Lift Table
Tie Rod End Remover
Steering Wheel Holder
Wooden Block
Materials
Name
Specification
Motorcraft® Threadlock 262TA-26
WSK-M2G351-A6
Removal
NOTICE:
Suspension fasteners are critical parts that affect the
performance of vital components and systems...
Other information:
Inspection
NOTE:
Procedure 1 — Ambient Temperature below 21 °C (70 °F).
NOTE:
Proper A/C system diagnosis on a vehicle’s
compressor is dependent on correct refrigerant system charge and tested
in ambient temperatures above 21°C (70°F)...
Launching or Retrieving a Boat or Personal Watercraft
When backing down a ramp during boat
launching or retrieval:
Do not allow the static water level to rise
above the bottom edge of the rear
bumper.
Do not allow waves to break higher than
6 in (15 cm) above the bottom edge of
the rear bumper...