Other information:
Removal
Side obstacle detection control module
NOTE:
This step is only necessary if the SODL or SODR is being replaced.
NOTE:
LH side is shown, RH side is similar.
Using a diagnostic scan tool, begin the PMI process for the SODL or SODR following the on-screen instructions.
Remove the rear bumper cover.
Refer to: Rear Bumper Cover (501-19 Bumpers)
.
..
Materials
Name
Specification
Motorcraft® Metal Brake Parts CleanerPM-4-A, PM-4-B, APM-4-C
-
Removal
NOTICE:
Do not spill brake fluid on painted or plastic surfaces or
damage to the surface may occur. If brake fluid is spilled onto a
painted or plastic surface, immediately wash the surface with water.
NOTE:
Removal steps in this procedure may contain installatio..
получение виз и в казахстане. Получение деловых виз в казахстане.