Lincoln Nautilus: Engine System - General Information / Piston Selection. General Procedures
Check
NOTE: Refer to the appropriate Section 303-01 for the specifications.
-
NOTE: The cylinder bore must be within the specifications for taper and out-of-round before fitting a piston.
-
Measure the cylinder bore in 2 directions.
-
Select a piston based on the cylinder bore.
-
Measure the cylinder bore in 2 directions.
 |
Piston Ring End Gap. General Procedures
Special Tool(s) /
General Equipment
Feeler Gauge
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
NOTE:
Use care when fitting piston rings to avoid possible damage to the piston ring or the cylinder bore...
Powertrain/Drivetrain Mount Neutralizing. General Procedures
Adjustment
NOTE:
Refer to the appropriate section and procedure for special instructions on loosening and tightening mount fasteners.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation)...
Other information:
Lincoln Nautilus 2018-2026 Owners Manual: Starting the Engine
Starting a Gasoline Engine Before starting your vehicle, check the following: Make sure that the headlamps and electrical accessories are off. Make sure that the parking brake is on. Make sure that the transmission is in park (P). Fully press the brake pedal...
Lincoln Nautilus 2018-2026 Service Manual: Rear Door Module (RDM). Removal and Installation
Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: If installing a new module, it is not necessary to upload the module configuration information to the diagnostic scan tool prior to removing the module. If the RDM is replaced with a part with the same suffix level, the DDM and PDM will automatically transfer the respective configuration to the new RD..
Categories
- Manuals Home
- 1st Generation Nautilus Owners Manual
- 1st Generation Nautilus Service Manual
- Auto-Start-Stop
- Auto Hold
- Replacing the Rear Wiper Blades
- New on site
- Most important about car
Auto-Start-Stop
What Is Auto-Start-Stop
The system is designed to help reduce fuel consumption and CO2 emissions by stopping the engine when it is idling, for example at traffic lights.
Auto-Start-Stop Precautions
WARNING: Apply the parking brake, shift into park (P), switch the ignition off and remove the key before you leave your vehicle. Failure to follow this instruction could result in personal injury or death.
WARNING: Apply the parking brake, shift into park (P), switch the ignition off and remove the key before you open the hood or have any service or repair work completed. If you do not switch the ignition off, the engine could restart at any time. Failure to follow this instruction could result in personal injury or d
