Lincoln Nautilus Manuals

Lincoln Nautilus: Suspension System - General Information / Specifications


  General Specifications

NOTE: Measurements listed at curb load. Curb load is defined as "full service fluids, full fuel tank(s), no passengers and no cargo".


Item Specification
Ball Joint Deflection
Lower 0.0 mm (0.0 in) - 0.2 mm (0.0079 in)
Ride Height
Front — (AWD and FWD - Vehicles with 21 inch wheels 56.7 mm (2.23 in) ± 11.8 mm (0.47 in)
Front — FWD - Vehicles without 21 inch wheels 62.4 mm (2.46 in) ± 11.8 mm (0.47 in)
Rear — (AWD and FWD - Vehicles with 21 inch wheels 34.3 mm (1.35 in) ± 14.0 mm (0.55 in)
Rear — FWD - Vehicles without 21 inch wheels 26.3 mm (1.04 in) ± 14.0 mm (0.55 in)

  Alignment Specifications

NOTE: Measurements listed at curb load. Curb load is defined as "full service fluids, full fuel tank(s), no passengers and no cargo".


Item LH RH Total / Split
Front
Camber -0.81° ± 0.75° -0.81° ± 0.75° 0.0° ± 0.75°
Caster 3.10° ± 0.75° 3.10° ± 0.75° 0.0° ± 0.75°
Toe @ curb ride height (positive value is toe in, negative value is toe out) 0.20° ± 0.20°
Rear
Camber (except vehicles with 21 inch wheels) -1.20° ± 0.75° -1.20° ± 0.75° 0.0°
Camber (vehicles with 21 inch wheels) -1.00° ± 0.75° -1.00° ± 0.75° 0.0°
Toe @ curb ride height (positive value is toe in, negative value is toe out) 0.13° ± 0.20° 0.13° ± 0.20° 0.26° ± 0.20°
Thrust angle

    Suspension System - General Information

    ..

    Suspension System. Diagnosis and Testing

    Preliminary Inspection Road test the vehicle. If any suspension alignment or ride height concerns are present, REFER to Symptom Chart: Suspension System...

    Other information:

    Lincoln Nautilus 2018-2026 Service Manual: Rear Halfshaft. Removal and Installation


    Special Tool(s) / General Equipment 100-001 (T50T-100-A) Slide Hammer 205-243Remover, HalfshaftTKIT-1986-LMTKIT-1986-F 205-832Remover, HalfshaftTKIT-2006C-FFMFLMTKIT-2006C-LMTKIT-2006C-ROW Removal NOTICE: Never pick up or hold the halfshaft by only the inner or outer Constant Velocity (CV) joint...

    Lincoln Nautilus 2018-2026 Service Manual: Evaporator Inlet and Outlet Manifold - 2.0L EcoBoost (184kW/250PS) – MI4. Removal and Installation


    Removal NOTICE: During the removal of components, cap, tape or otherwise appropriately protect all openings to prevent the ingress of dirt or other contamination. Remove protective materials prior to installation. NOTE: Removal steps in this procedure may contain installation details...

    Categories

    Opening and Closing the Hood

    Opening the Hood

    Lincoln Nautilus. Opening and Closing the Hood

    Inside the vehicle, pull the hood release handle located under the left-hand side of the instrument panel.

    read more

    Copyright © 2026 www.linautilus.com