Lincoln Nautilus: Climate Control System - General Information / Specifications
Lubricants, Fluids and Capacities
NOTE: Per the warranty and policy manual the Ford Engineering-approved refrigerant (see table for service part number) must be used for air conditioning repairs.
| ITEM | CAPACITIES |
|---|---|
| Material: Motorcraft® PAG Refrigerant Compressor Oil / YN-12-D (WSH-M1C231-B) (Mexico) | 3.2 fl oz (95 ml) |
| Material: Motorcraft® R-1234yf Refrigerant PAG Oil / YN-35 (WSS-M2C300-A2) (US, Canada) | 3.2 fl oz (95 ml) |
| Material: Motorcraft® R-134a Refrigerant / YN-19 (WSH-M17B19-A) (Mexico) | 2.0L EcoBoost 22 oz (0.62 kg) |
| 2.7L EcoBoost 22 oz (0.62 kg) | |
| Material: R-1234yf Refrigerant / YN-33-A (WSS-M17B21-A) (US, Canada) | 2.0L EcoBoost 21 oz (0.59 kg) |
| 2.7L EcoBoost 21 oz (0.59 kg) | |
| Material: Motorcraft® A/C System Flushing Solvent / YN-23 | — |
| Material: Motorcraft® A/C Cooling Coil Coating / YN-29 | — |
A/C Compressor Clutch Air Gap
| Item | mm |
|---|---|
| A/C compressor clutch air gap | 0.3 — 0.6 |
Climate Control System - Component Location. Description and Operation
Item
Description
1
Driver side register
2
In-vehicle temperature & humidity sensor
3
Sunload sensor
4
Passenger side register
5
HVAC control module
6
Center registers
Item
Description
1
Heater core
2
Driver side footwell air discharge temperature sensor
3
Evaporator temperature sensor
4
..
Other information:
Lincoln Nautilus 2018-2026 Service Manual: Exterior Mirror. Removal and Installation
Removal NOTE: Removal steps in this procedure may contain installation details. Exterior mirror assembly Remove the ft door interior trim panel. Refer to: Front Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation). Disconnect the exterior rear view mirror electrical connector and remove the seal. Remove t..
Lincoln Nautilus 2018-2026 Service Manual: Dash Panel. Removal and Installation
Special Tool(s) / General Equipment Scraper for Straight Edges Hot Air Gun 8 mm Drill Bit MIG/MAG Welding Equipment Spot Weld Drill Bit Locking Pliers Materials Name Specification Seam SealerTA-2-B, 3M™ 08308, LORD Fusor® 803DTM - Removal NOTE: Roof removed for clarity. NOTE: Factory welds may be substituted with resistance or me..
Categories
- Manuals Home
- 1st Generation Nautilus Owners Manual
- 1st Generation Nautilus Service Manual
- Power Outlet - Vehicles With: 110V Power Outlet
- Locating the Pre-Collision Assist Sensors
- Massage Seats
- New on site
- Most important about car
Changing a Flat Tire
WARNING: If the tire pressure monitor sensor becomes damaged it may not function.
Note: The use of tire sealant may damage your tire pressure monitoring system and should only be used in roadside emergencies. If you must use a sealant, use the Tire Mobility Kit sealant. Replace the tire pressure monitoring system sensor and valve stem on the wheel by an authorized dealer after use of the sealant.
Note: The tire pressure monitoring system indicator light will illuminate when the spare tire is in use. To restore the full function of the monitoring system, all road wheels equipped with tire pressure monitoring sensors must be mounted on the vehicle.
If you get a flat tire while driving, do not apply the brake hea
