Lincoln Nautilus: Wipers and Washers / Wipers and Washers - Overview. Description and Operation
Overview
The
windshield wiper/washer system is activated by the wiper/washer switch.
The following functions/features of the windshield wiper/washer system
are:
-
Mist wipe
-
Windshield wash (includes camera wash, if equipped)
-
Courtesy wipe
-
Windshield wipers (low/high speed)
-
Intermittent wipers
-
Speed dependent wipers
-
Wiper activated exterior lamps
-
Rain sensitive wipers (if equipped)
-
Rear window wipe
-
Rear window wash
-
Headlamp wash (if equipped)
There are 6 intermittent/sensitivity settings to choose from for the intermittent/rain sensitive wipers.
There are 2 settings to choose from for the rear window wiper operation.
Heated Wiper Park Overview
When the rear window defrost button (integral to the FCIM ) is
pressed, the FCIM activates the heated wiper park relay (located in the
BJB ). When the heated wiper park relay is active, the heated wiper park
grids are energized.
System Operation
System Diagram
Item
Description
1
HS3-CAN
2
LIN
3
Wiper/Washer Switch
4
Rain Sensor
5
Washer Motor
6
SCCM
7
Windshield Wiper Motor
8
HS2-CAN
9
GWM
10
BCM
11
IPC
12
HS-CAN 1
13
PCM
14
BJB
15
Wiper Relay
16
BJB
17
Rear Window Washer Relay
18
Headlamp Washe..
Other information:
Removal
Side obstacle detection control module
NOTE:
This step is only necessary if the SODL or SODR is being replaced.
NOTE:
LH side is shown, RH side is similar.
Using a diagnostic scan tool, begin the PMI process for the SODL or SODR following the on-screen instructions.
Remove the rear bumper cover.
Refer to: Rear Bumper Cover (501-19 Bumpers)
.
..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
The HCU and ABS module are released individually. A new HCU does not come equipped with an ABS module.
Remove the battery tray.
If equipped.
Remove the nut, bolt and the battery tray support bracket.
Torque:
18 lb.ft (24 Nm)
Disconnect the A..