Other information:
Removal
NOTE:
This procedure can be used for all locations of the component.
Remove the screw cover.
Remove the screw and position the rear lamp assembly.
Disconnect the electrical connector and remove the rear lamp assembly.
Installation
To install, reverse the removal procedure.
..
Special Tool(s) /
General Equipment
MIG/MAG Welding Equipment
Spot Weld Drill Bit
Removal
NOTICE:
The rear side member(s) are constructed of Dual Phase
(DP) 800 steel and cannot be sectioned. Side member assembly must be
replaced at factory joints.
Restore vehicle to pre-accident dimensions, if required.
Refer to: Body and Frame (501-26 Body Repairs - Vehicle Sp..