Lincoln Nautilus: Roof Opening Panel / Air Deflector. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Place the roof opening panel glass in the fully OPEN position.
   

1. 
   Disconnect the front of the air deflector.
   

   1. NOTE: RH side shown, LH side similar.

      On both sides.
      Disconnect the outside wire by pushing inward.
      
   2. Slide the air deflector wire forward to release the front of the air deflector from the clips.
      

1. NOTE: LH side shown, RH side similar.

   On both sides.
   Tilt the front of the air deflector up and roll the rear of the arm out of the retaining clip on the frame.
   

Installation

1. To install, reverse the removal procedure.
   

1. Carry out the roof opening panel initialization.
   Refer to: Power Roof Opening Panel Initialization (501-17 Roof Opening Panel, General Procedures).