Lincoln Nautilus: Blind Spot Information System / Blind Spot Information System Requirements. Switching Blind Spot Information System On and Off
Blind Spot Information System Requirements
Blind spot information system turns on when
all the following occur:
- You start your vehicle.
- You shift into drive (D).
- The vehicle speed is greater than 6 mph
(10 km/h).
Switching Blind Spot Information System On and Off
To switch blind spot information system on
or off, use the instrument cluster display:
- Using the instrument cluster display
controls on the steering wheel, select
SETTINGS.
- Select Driver assistance.
- Switch Blindspot on or off.
When you switch blind spot information
system off, a warning lamp illuminates and
a message displays. When you switch the
system on or off, the alert indicators flash
twice.
Note: The system remembers the last setting
when you start your vehicle.
To permanently switch the system off,
contact an authorized dealer.
What Is Blind Spot Information System
Blind spot information system detects
vehicles that may have entered the blind
spot zone.
How Does Blind Spot Information System Work
Blind spot information system uses sensors
on both sides of your vehicle, detecting
rearward from the exterior mirrors to
approximately 13 ft (4 m) beyond the rear
bumper...
Locating the Blind Spot Information System Sensors
The sensors are behind the rear bumper on
both sides of your vehicle.
Note: Keep the sensors free from snow, ice
and large accumulations of dirt...
Other information:
If you are unable to start the engine, do the
following:
Open the floor console storage
compartment lid.
With the buttons facing upward and the
unlock button facing the front of your
vehicle, place the passive key into the
backup slot.
With the key in this position, press the
brake pedal then press the push button
ignition switch to switch the ignition on
and start your vehicle...
Special Tool(s) /
General Equipment
Resistance Spotwelding Equipment
8 mm Drill Bit
Spot Weld Drill Bit
Locking Pliers
Materials
Name
Specification
Seam SealerTA-2-B, 3M™ 08308, LORD Fusor® 803DTM
-
Removal
NOTE:
Factory welds may be substituted with resistance or metal
inert gas (MIG) plug welds...