Lincoln Nautilus: Rear Disc Brake / Brake Caliper Anchor Plate. Removal and Installation
Removal
NOTE:
Steps in the removal procedure may contain installation details.
-
Remove the brake pads.
Refer to: Brake Pads (206-04 Rear Disc Brake, Removal and Installation).
-
Remove the bolts and the brake caliper anchor plate. Discard the bolts.
Torque:
76 lb.ft (103 Nm)
Installation
-
To install, reverse the removal procedure.
Removal
NOTICE:
Do not spill brake fluid on painted or plastic surfaces or
damage to the surface may occur. If brake fluid is spilled onto a
painted or plastic surface, immediately wash the surface with water...
Materials
Name
Specification
Motorcraft® Metal Brake Parts CleanerPM-4-A, PM-4-B, APM-4-C
-
Removal
NOTE:
Removal steps in this procedure may contain installation instructions...
Other information:
Checking the Seatbelts
Check the seatbelts and child restraints
periodically to make sure they work properly
and are not damaged. Make sure there are
no nicks, tears or cuts. Replace if necessary.
Check the following seatbelt assemblies after
a crash...
Removal
NOTICE:
If installing a new A/C compressor due to an internal failure of the
old unit, carry out the following procedures to remove contamination
from the A/C system. Failure to remove contamination from the A/C
system, if present, will result in poor A/C performance and/or damage to
the new A/C compressor and other components...