Other information:
Removal
NOTE:
If installing a new PAM
, it is necessary to upload the module configuration information to the
scan tool prior to removing the module. This information must be
downloaded into the new PAM after installation.
Using a diagnostic scan tool, begin the PMI process for the PAM following the onscreen instructions.
Remove the driver knee airbag.
Refer to: ..
Removal
NOTE:
LH side shown, RH side similar.
NOTE:
Removal steps in this procedure may contain installation details.
NOTICE:
To avoid damage to moulding, only use moderate force.
Using a non-marring trim removal tool, disengage the retainer clips.
Remove the moulding.
Installation
To install, reverse the re..