Lincoln Nautilus: Climate Control System - General Information / Evaporator Temperature Sensor. Removal and Installation
Removal
NOTE:
The evaporator temperature sensor is available only as part of the climate control housing.
-
Remove the climate control housing.
Refer to: Climate Control Housing (412-00)
.
Installation
-
Transfer the components from the old housing to the new housing as needed.
-
To install, reverse the removal procedure.
Removal
NOTICE:
During the removal of components, cap, tape or otherwise
appropriately protect all openings to prevent the ingress of dirt or
other contamination...
Removal
NOTE:
If a heater core leak is suspected, the heater core must be leak tested before it is removed from the vehicle.
Remove the climate control housing...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the diagnostic scan tool
prior to removing the module. This information must be downloaded into
the new module after installation...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Open the media bin cover.
Using a non-marring tool, release the clips and position the media hub out.
Disconnect the connectors and remove the media hub...