Lincoln Nautilus Manuals

Lincoln Nautilus: Parking Brake and Actuation / Parking Brake Switch. Removal and Installation

Lincoln Nautilus 2018-2025 Service Manual / Chassis / Brake System / Parking Brake and Actuation / Parking Brake Switch. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

  1. Detach the clips and pivot the instrument panel LH lower trim panel downward.
  1. Disconnect the EPB switch electrical connector.
  1. Remove the 3 screws and the EPB switch.

Installation

  1. To install, reverse the removal procedure.
  1. NOTE: Anytime the parking brake switch electrical connector has been disconnected, the EPB system is deactivated and a DTC is stored in the ABS module. Perform the following step to restore the EPB system and clear the ABS module DTC .

    Apply and release the parking brake twice within 5 seconds, pausing with the switch in the NEUTRAL position for approximately one-half second between each apply and release.

    Parking Brake Actuator Motor. Removal and Installation

    Removal NOTE: Removal steps in this procedure may contain installation details. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation)...

    Hydraulic Brake Actuation

    ..

    Other information:

    Lincoln Nautilus 2018-2025 Owners Manual: Massage Seats


    Massage Seat Limitations The engine must be running or the vehicle must be in accessory mode to activate the seats. Allow a few seconds for any selection to activate. When the seat backrest and cushion are both active, the massage alternates between zones. Adjusting the Massage Seat Settings Select the previous massage pattern or lumbar area. Decrease the massage or lumbar Intensity. ..

    Lincoln Nautilus 2018-2025 Service Manual: Rear Parking Aid Camera. Removal and Installation


    Removal Remove the liftgate trim panel. Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation). Release the inside connections and nuts from the reversing lamp assembly. Remove the reversing lamp nuts. Torque: 28 lb.in (3.2 Nm) Disconnect the electrical connectors. Push the grommet through the liftg..

    Categories

    Auto-Start-Stop

    What Is Auto-Start-Stop

    The system is designed to help reduce fuel consumption and CO2 emissions by stopping the engine when it is idling, for example at traffic lights.

    Auto-Start-Stop Precautions

    WARNING: Apply the parking brake, shift into park (P), switch the ignition off and remove the key before you leave your vehicle. Failure to follow this instruction could result in personal injury or death.

    WARNING: Apply the parking brake, shift into park (P), switch the ignition off and remove the key before you open the hood or have any service or repair work completed. If you do not switch the ignition off, the engine could restart at any time. Failure to follow this instruction could result in personal injury or d

    read more

    Copyright © 2025 www.linautilus.com