Lincoln Nautilus: Roof Opening Panel / Roof Opening Panel Glass. Removal and Installation

Lincoln Nautilus 2018-2026 Service Manual / Body and Paint / Body and Paint / Roof Opening Panel / Roof Opening Panel Glass. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

NOTE: This procedure is for the sliding glass panel only.

Place the roof opening panel shield to the fully OPEN position.

NOTE: RH side shown, LH side similar.
On both sides.
Detach part of the roof opening panel seal from the roof opening panel frame as necessary.

NOTE: RH side shown, LH side similar.
On both sides.
Remove the 6 roof opening panel glass retainers.
Torque: 49 lb.in (5.5 Nm)

With the help of an assistant
Remove the roof opening panel glass.

Installation

To install, reverse the removal procedure.

Align the sliding glass panel.
Refer to: Roof Opening Panel Alignment (501-17 Roof Opening Panel, General Procedures).

Roof Opening Panel Frame. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the roof opening panel glass. Refer to: Roof Opening Panel Glass (501-17 Roof Opening Panel, Removal and Installation)...

Roof Opening Panel Motor. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Place the roof opening panel glass in the fully CLOSE position...

Other information:

Lincoln Nautilus 2018-2026 Owners Manual: What Is the Tire Sealant and Inflator Kit. Tire Sealant and Inflator Kit Precautions

What Is the Tire Sealant and Inflator Kit Tire Inflator and Sealant Kit The kit consists of an air compressor to re-inflate the tire and a canister of sealing compound that will effectively seal most punctures. This kit will provide a temporary tire repair allowing you to drive your vehicle up to 120 mi (200 km) at a maximum speed of 50 mph (80 km/h) to reach a tire service location...

Lincoln Nautilus 2018-2026 Service Manual: Brake Caliper. Removal and Installation

Materials Name Specification Motorcraft® Metal Brake Parts CleanerPM-4-A, PM-4-B, APM-4-C - Removal NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water...

Changing a Flat Tire

WARNING: If the tire pressure monitor sensor becomes damaged it may not function.

Note: The use of tire sealant may damage your tire pressure monitoring system and should only be used in roadside emergencies. If you must use a sealant, use the Tire Mobility Kit sealant. Replace the tire pressure monitoring system sensor and valve stem on the wheel by an authorized dealer after use of the sealant.

Note: The tire pressure monitoring system indicator light will illuminate when the spare tire is in use. To restore the full function of the monitoring system, all road wheels equipped with tire pressure monitoring sensors must be mounted on the vehicle.

If you get a flat tire while driving, do not apply the brake hea