Other information:
Removal
NOTE:
This step is only necessary if the IPMB is being replaced.
NOTE:
This procedure can be used for all locations of the component.
Using a diagnostic scan tool, begin the PMI process for the IPMB following the on-screen instructions.
Position the front driver seat to access the IPMB .
Remove the retainers and the IPMB cove..
Removal
NOTE:
LH side shown, RH side similar.
Remove the front door latch.
Refer to: Front Door Latch (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation).
NOTE:
This step is only necessary when installing a new component.
Remove the exterior front door handle reinforcement.
Tighten the screw to release the front exterior handle actuat..