Lincoln Nautilus: Wipers and Washers / Reverse Wipe. Checking the Wiper Blades
Reverse Wipe
What Is Reverse Wipe
Reverse wipe turns on the rear window wiper
when you shift into reverse (R) and the
windshield wipers are on.
Reverse Wipe Settings
- Using the instrument cluster controls on
the steering wheel, select Settings.
- Select Vehicle.
- Select Wipers.
- Switch Reverse Wiper on or off.
Checking the Wiper Blades

Run the tip of your fingers over the edge of
the blade to check for roughness.
Replacing the Front Wiper Blades
Lift the wiper arm and then press the
wiper blade locking buttons together.Note: Do not hold the wiper
blade to lift the
wiper arm...
Other information:
Removal
Remove the overhead console.
Refer to: Overhead Console (501-12 Instrument Panel and Console, Removal and Installation).
Release the tabs and position aside the sensors.
Position aside the wire harness...
NOTE:
If an overnight drive is done, the fan air or road air blast can cause erroneous readings.
NOTE:
When diagnosing engine oil leaks, the source and location of the leak must be positively identified prior to repair.
Prior to carrying out this procedure, clean the cylinder
block, cylinder heads, valve covers, oil pan and flywheel/flexplate with
a suitable solvent to remove al..
Categories
WARNING: If the tire pressure
monitor sensor becomes damaged it may
not function.
Note: The use of tire sealant may damage
your tire pressure monitoring system and
should only be used in roadside
emergencies. If you must use a sealant, use
the Tire Mobility Kit sealant. Replace the tire
pressure monitoring system sensor and
valve stem on the wheel by an authorized
dealer after use of the sealant.
Note: The tire pressure monitoring system
indicator light will illuminate when the spare
tire is in use. To restore the full function of
the monitoring system, all road wheels
equipped with tire pressure monitoring
sensors must be mounted on the vehicle.
If you get a flat tire while driving, do not apply
the brake hea
read more