Lincoln Nautilus: Front Drive Halfshafts / Specifications
Lubricants, Fluids, Sealers and Adhesives
|
Item
|
Specifications
|
|
Intermediate shaft bearing O-ring seal
|
Motorcraft® MERCON® ULV Automatic Transmission Fluid XT-12-QULV
|
Torque Specifications
NOTE:
Applicable only for FWD vehicles.
|
Item
|
Nm
|
lb-ft
|
lb-in
|
|
Halfshaft support bracket-to-engine block bolts
|
48
|
35
|
–
|
|
Halfshaft support bracket nuts
|
25
|
18
|
–
|
Preliminary Inspection
Visually inspect the CV joints, housing, boots, and clamps for obvious signs of mechanical damage.
If an obvious cause for an observed or reported concern is
found, correct the cause (if possible) before proceeding to the next
step
If the cause is not visually evident, verify the symptom and REFER to Symptom Chart: NVH...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
This step is only necessary when installing a new component.
NOTE:
The PMI process must begin with the current SCCM installed. If the
current SCCM does not respond to the diagnostic scan tool, the tool may
prompt for As-Built Data as part of the repair...
Adjustment
NOTE:
Refer to the appropriate section and procedure for special instructions on loosening and tightening mount fasteners.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
Loosen, but do not remove, the powertrain/drivetrain mount fasteners...