Lincoln Nautilus: Brake System - General Information / Specifications
Lubricants, Fluids, Sealers and Adhesives
| Item | Specifications |
|---|---|
| Motorcraft® DOT 4 LV High Performance Motor Vehicle Brake Fluid / PM-20 | WSS-M6C65-A2 |
Torque Specifications
| Item | Nm | lb-ft | lb-in |
|---|---|---|---|
| Front caliper bleeder screw | 17 | - | 150 |
| Rear caliper bleeder screw | 17 | - | 150 |
| Master cylinder brake tube fittings | 27.5 | 20 | - |
General Specifications
| Item | Specification |
|---|---|
| Front brake disc minimum thickness | 1.201 in ( 30.5 mm) |
| Rear brake disc minimum thickness (17") | 0.374 in ( 9.5 mm) |
| Rear brake disc minimum thickness (18") | 0.689 in ( 17.5 mm) |
| Brake pad minimum thickness | 0.118 in ( 3 mm) |
| Brake pad maximum taper wear (in any direction) | 0.118 in ( 3 mm) |
Brake System. Diagnosis and Testing
Symptom Chart(s)
Symptom Chart: Brake System
Diagnostics
in this manual assume a certain skill level and knowledge of
Ford-specific diagnostic practices...
Other information:
Lincoln Nautilus 2018-2026 Service Manual: Seatbelt Shoulder Height Adjuster. Removal and Installation
Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LH shown, RH similar. Remove the B-pillar trim panel. Refer to: B-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Lincoln Nautilus 2018-2026 Service Manual: Roof Panel - Vehicles With: Panoramic Roof Opening Panel. Removal and Installation
Special Tool(s) / General Equipment Resistance Spotwelding Equipment Scraper for Straight Edges Spherical Cutter Hot Air Gun Spot Weld Drill Bit Locking Pliers Materials Name Specification Metal Bonding AdhesiveTA-1, TA-1-B, 3M™ 08115, LORD Fusor® 108B, Henkel Teroson EP 5055 - Seam SealerTA-2-B, 3M™ 08308, LORD Fusor® 803DTM - ..
Categories
- Manuals Home
- 1st Generation Nautilus Owners Manual
- 1st Generation Nautilus Service Manual
- Opening the Liftgate
- Auto Hold
- Power Outlet - Vehicles With: 110V Power Outlet
- New on site
- Most important about car
Traction Control
How Does Traction Control Work
If your vehicle begins to slide, the system applies the brakes to individual wheels and, when needed, reduces power at the same time. If the wheels spin when accelerating on slippery or loose surfaces, the system reduces power in order to increase traction.
Switching Traction Control On and Off
WARNING: The stability and traction control light illuminates steadily if the system detects a failure. Make sure you did not manually disable the traction control system using the information display controls or the switch. If the stability control and traction control light is still illuminating steadily, have the system serviced by an authorized dealer immediately. Operating your vehicle with the traction co
