Lincoln Nautilus: Roof Opening Panel / Specifications
Specifications
| Item | Specification |
|---|---|
| Rear fixed glass panel to roof flushness, side (at front of glass) | -0.08 - 0.0 in (-0.5 - 0.0 mm) |
| Rear fixed glass panel to roof flushness, rear | 0.08 - 0.0 in (0.5 - 0.0 mm) |
| Front sliding glass panel to roof flushness, front | -0.06 - 0.0 in (-1.5 - 0.0 mm) |
| Front sliding glass panel to rear fixed glass panel flushness | 0.08 - 0.0 in (0.5 - 0.0 mm) |
Roof Opening Panel. Description and Operation
Roof Opening Panel
The roof opening panel consists of the following:
Air deflector
Sliding glass panel
Sliding glass panel motor
Shield assembly
Shield motor
Roof opening panel fixed glass
Roof opening panel frame assembly
Roof opening panel drain hoses
Roof opening panel control switch
Roof opening panel seal
The
roof opening panel motor m..
Other information:
Lincoln Nautilus 2018-2026 Service Manual: Front Door Moulding. Removal and Installation
Removal NOTE: LH side shown, RH side similar. NOTE: Removal steps in this procedure may contain installation details. NOTICE: To avoid damage to moulding, only use moderate force. Using a non-marring trim removal tool, disengage the retainer clips. Remove the moulding. Installation To install, reverse the re..
Lincoln Nautilus 2018-2026 Service Manual: Evaporator. Removal and Installation
Removal Remove the climate control housing. Refer to: Climate Control Housing (412-00 Climate Control System - General Information) . Remove the heater tube dash panel seal. Remove the retainers, release the clip and position the heater tube bracket aside. Remove the heater core. ..
Categories
- Manuals Home
- 1st Generation Nautilus Owners Manual
- 1st Generation Nautilus Service Manual
- USB Ports
- Opening and Closing the Hood
- Replacing the Rear Wiper Blades
- New on site
- Most important about car
Changing a Flat Tire
WARNING: If the tire pressure monitor sensor becomes damaged it may not function.
Note: The use of tire sealant may damage your tire pressure monitoring system and should only be used in roadside emergencies. If you must use a sealant, use the Tire Mobility Kit sealant. Replace the tire pressure monitoring system sensor and valve stem on the wheel by an authorized dealer after use of the sealant.
Note: The tire pressure monitoring system indicator light will illuminate when the spare tire is in use. To restore the full function of the monitoring system, all road wheels equipped with tire pressure monitoring sensors must be mounted on the vehicle.
If you get a flat tire while driving, do not apply the brake hea
