Lincoln Nautilus: Roof Opening Panel / Roof Opening Panel. Description and Operation

Roof Opening Panel

The roof opening panel consists of the following:

• Air deflector
• Sliding glass panel
• Sliding glass panel motor
• Shield assembly
• Shield motor
• Roof opening panel fixed glass
• Roof opening panel frame assembly
• Roof opening panel drain hoses
• Roof opening panel control switch
• Roof opening panel seal

The roof opening panel motor must be initialized when repairs are carried out on the roof opening panel system, including: any time the roof opening panel motor has been removed, the roof opening panel glass (sliding or fixed glass) has been removed or adjusted, or if the roof opening panel frame has been removed.
For additional information, refer to: Power Roof Opening Panel Initialization (501-17 Roof Opening Panel, General Procedures).

The accessory delay relay, located in the BCM , that provides voltage for the operation of the power windows and the roof opening panel. For additional information,
For additional information, refer to: Glass, Frames and Mechanisms (501-11) .
, Glass, Frames and Mechanisms Delayed Accessory Power.

The roof opening panel is an electronically operated glass panel that can be opened, closed or tilted (vent position) by the roof opening panel control switch, the shield switch, and the vent switch. Actuating the switches supplies a signal to the roof opening panel glass and shield motor/module. The front sliding glass panel and the shield use two integrated motors/modules that are serviced as assemblies. The roof opening panel and shield has one-touch open and one-touch close features that are activated when the switch is pressed and immediately released (less than 0.5 seconds) on the open or close side of the switch. For manual control holding the switch depressed for more than 0.5 seconds will cancel one-touch operation and the sliding glass panel or shield will stop when the switch is released.

Additionally there is a roof opening panel fixed glass panel behind the sliding glass panel. The roof opening panel fixed glass is attached with 6 screws and can be aligned.