Lincoln Nautilus: Engine System - General Information / Valve Guide Inner Diameter. General Procedures
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
-
NOTE:
Valve guides tend to wear in an hourglass pattern.
The ball gauge can be inserted into the combustion chamber side of the
valve guide, if necessary.
-
Use a ball gauge to determine the inside diameter of
the valve guides in 2 directions at the top, middle and bottom of the
valve guide.
-
Measure the ball gauge with a micrometer.
-
If the valve guide is not within specifications, install a new cylinder head assembly.
Inspection
NOTE:
Dropped spark plugs should always be discarded.
Unfired
An unfired spark plug should appear very clean
with a pure nickel finish to the threads and ground strap...
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
Measure the diameter of each intake and exhaust valve
stem at the points shown...
Other information:
Special Tool(s) /
General Equipment
8 mm Drill Bit
MIG/MAG Welding Equipment
Spot Weld Drill Bit
Locking Pliers
Materials
Name
Specification
Seam SealerTA-2-B, 3M™ 08308, LORD Fusor® 803DTM
-
Removal
NOTE:
Left hand (LH) side shown, right hand (RH) side similar...
Materials
Name
Specification
Motorcraft® MERCON® ULV Automatic Transmission FluidXT-12-QULV
WSS-M2C949-A, MERCON® ULV
Removal
Remove the front halfshaft RH .
Refer to: Front Halfshaft RH - 2.0L EcoBoost (184kW/250PS) – MI4,
All-Wheel Drive (AWD) (205-04 Front Drive Halfshafts, Removal and
Installation)...