Lincoln Nautilus: Information and Entertainment System - General Information - Vehicles With: SYNC 4 / Audio Unit Antenna Amplifier. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
All vehicles
-
Remove the liftgate trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
All vehicles except China
-
Remove the bolt and the audio unit antenna amplifier.
-
Disconnect the electrical connectors.
Torque:
93 lb.in (10.5 Nm)
China vehicles only
-
Remove the bolt and the audio unit antenna amplifier.
-
Disconnect the electrical connectors.
Torque:
93 lb.in (10.5 Nm)
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
AM Antenna.
NOTE:
The AM antenna is part of the rear spoiler...
Removal
NOTE:
The original equipment body and liftgate audio unit antenna
cable(s) are part of the wiring harness and cannot be removed. This
procedure refers to replacement of the cable(s) only by overlaying the
cable(s)...
Other information:
Leak detection
Review next note for important refrigerant system dye information.
NOTE:
Fluorescent refrigerant system dye is added to the
refrigerant system at the factory to assist in refrigerant system leak
diagnosis using a Rotunda-approved UV
lamp...
Removal
Remove the headlamp assembly.
Refer to: Headlamp Assembly (417-01 Exterior Lighting, Removal and Installation).
Remove the screws and position the adaptive front lighting module to access the connectors.
Disconnect the electrical connectors and remove the adaptive front lighting module...