Other information:
Removal
NOTE:
LH side shown, RH side similar.
NOTE:
Removal steps in this procedure may contain installation details.
Remove the pushpins and clip from the rear of the moulding.
Remove the pushpins at the front edge of the moulding.
NOTICE:
To avoid damage to the moulding, only use moderate force.
Using a n..
Special Tool(s) /
General Equipment
Feeler Gauge
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
NOTE:
Make sure all cylinder head surfaces are clear of
any gasket material, silicone sealant, oil and coolant. The cylinder
head surface must be clean and dry before running a flatness check.
NOTE:
Use a Straightedge that is calibrated by th..