Lincoln Nautilus: Front Disc Brake / Brake Caliper Anchor Plate. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the brake pads.
Refer to: Brake Pads (206-03 Front Disc Brake, Removal and Installation).
-
Remove the bolts and the brake caliper anchor plate. Discard the bolts.
Torque:
122 lb.ft (165 Nm)
Installation
-
NOTICE:
Make sure that the brake hose is not twisted when
installing the brake caliper or damage to the brake flexible hose may
occur.
To install, reverse the removal procedure.
Materials
Name
Specification
Motorcraft® Metal Brake Parts CleanerPM-4-A, PM-4-B, APM-4-C
-
Removal
NOTICE:
Do not spill brake fluid on painted or plastic surfaces or
damage to the surface may occur...
Materials
Name
Specification
Motorcraft® Metal Brake Parts CleanerPM-4-A, PM-4-B, APM-4-C
-
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
Steering Column Switches Overview
The
steering column switches are located on and around the steering column.
They enable the driver to control various vehicle functions while
remaining focused on driving. The steering column switches consist of:
Left multifunction switch - controls the turn signals,
low/high beam and flash-to-pass headlamp functions...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new module, it is not necessary to upload
the module configuration information to the diagnostic scan tool prior
to removing the module. If the RDM is replaced with a part with the same
suffix level, the DDM and PDM will automatically transfer the
respective configuration to the new RD..