Lincoln Nautilus: Climate Control / Setting the Temperature. Directing the Flow of Air
Setting the Temperature
Press the toggle button on the
left-hand side
of the climate control upward or downward
to set the left-hand temperature.
Note: This control also adjusts the right-hand side temperature when you switch off dual zone mode.
Press the toggle button on the right-hand side of the climate control upward or downward to set the right-hand temperature.
Directing the Flow of Air
Directing Air to the Windshield Air Vents
Press the button to activate the
selection screen.
Press the button on the
touchscreen.
Directing Air to the Instrument Panel Air Vents
Press the button to activate the
selection screen.
Press the button on the
touchscreen.
Directing Air to the Footwell Air Vents
Press the button to activate the
selection screen.
Press the button on the
touchscreen.
Switching the Heated Rear Window On and Off. Switching the Heated Mirrors On and Off. Setting the Blower Motor Speed
Switching the Heated Rear Window On and Off
Press the button to clear the
rear
window of thin ice and fog. The
heated rear window turns off after
a short period of time...
Auto Mode
Switching Auto Mode On and Off
Press the button to switch auto
mode on. Repeatedly press the
button to adjust auto mode.
The system adjusts the blower motor speed,
air distribution, air conditioning operation,
and outside or recirculated air to reach and
maintain the temperature you have set...
Other information:
Lincoln Nautilus 2018-2025 Service Manual: Component Bleeding. General Procedures
Special Tool(s) / General Equipment Master Cylinder Bleeding Set Bleeding NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water. Master Cylinder NOTE: When a new brake master cylinder has been installed, it should be primed to prevent air from entering the system...
Lincoln Nautilus 2018-2025 Owners Manual: Reduced Engine Performance. Cold Weather Precautions
Reduced Engine Performance WARNING: If you continue to drive your vehicle when the engine is overheating, the engine could stop without warning. Failure to follow this instruction could result in the loss of control of your vehicle. If the engine coolant temperature gauge needle moves to the upper limit position, the engine is overheating...
Categories
- Manuals Home
- 1st Generation Nautilus Owners Manual
- 1st Generation Nautilus Service Manual
- Power Outlet - Vehicles With: 110V Power Outlet
- Auto-Start-Stop
- Opening the Liftgate
- New on site
- Most important about car
Changing a Flat Tire
WARNING: If the tire pressure monitor sensor becomes damaged it may not function.
Note: The use of tire sealant may damage your tire pressure monitoring system and should only be used in roadside emergencies. If you must use a sealant, use the Tire Mobility Kit sealant. Replace the tire pressure monitoring system sensor and valve stem on the wheel by an authorized dealer after use of the sealant.
Note: The tire pressure monitoring system indicator light will illuminate when the spare tire is in use. To restore the full function of the monitoring system, all road wheels equipped with tire pressure monitoring sensors must be mounted on the vehicle.
If you get a flat tire while driving, do not apply the brake hea
