Lincoln Nautilus: Capacities and Specifications / Brake Fluid Specification
Use fluid that meets the defined specification
and viscosity grade.
If you do not use fluid that meets the defined
specification and viscosity grade, it could
result in:
- Component damage that your vehicle
warranty does not cover.
- Reduced brake performance.
Note: We recommend you use DOT 4 Low
Viscosity (LV) High Performance Brake Fluid
or equivalent meeting WSS-M6C65-A2. If
you use any fluid other than the
recommended fluid, it could cause reduced
brake performance and not meet our
performance standards. Keep brake fluid
clean and dry. Contamination with dirt,
water, petroleum products or other materials
could result in brake system damage and
possible failure.
Capacities

Materials

Locating the Vehicle Identification Number
The vehicle identification number is located
on the left-hand side of the instrument panel.
In the graphic, XXXX is representative of
your vehicle identification number...
Other information:
Special Tool(s) /
General Equipment
MIG/MAG Welding Equipment
Spot Weld Drill Bit
Removal
NOTICE:
The rear side member(s) are constructed of Dual Phase
(DP) 800 steel and cannot be sectioned. Side member assembly must be
replaced at factory joints...
Preliminary Inspection
Visually inspect the CV joints, housing, boots, and clamps for obvious signs of mechanical damage.
If an obvious cause for an observed or reported concern is
found, correct the cause (if possible) before proceeding to the next
step
If the cause is not visually evident, verify the symptom and REFER to Symptom Chart: NVH...