Lincoln Nautilus: Engine System - General Information / Cylinder Bore Taper. General Procedures

Lincoln Nautilus 2018-2026 Service Manual / Powertrain / Engine / Engine System - General Information / Cylinder Bore Taper. General Procedures

Check

NOTE: Refer to the appropriate Section 303-01 for the specification.

Measure the cylinder bore at the top, middle and bottom of piston ring travel in 2 directions as indicated. Verify the cylinder bore is within the wear limit. The difference indicates the cylinder bore taper. If the cylinder bore taper does not meet specification, bore the cylinder to the next oversize limit.

Cylinder Block Distortion. General Procedures

Special Tool(s) / General Equipment Feeler Gauge Check NOTE: Refer to the appropriate Section 303-01 for the specification. NOTE: Use a Straightedge that is calibrated by the manufacturer to be flat within 0...

Cylinder Head Distortion. General Procedures

Special Tool(s) / General Equipment Feeler Gauge Check NOTE: Refer to the appropriate Section 303-01 for the specification. NOTE: Make sure all cylinder head surfaces are clear of any gasket material, silicone sealant, oil and coolant...

Other information:

Lincoln Nautilus 2018-2026 Service Manual: Wiper Linkage Assembly. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: Hood removed in this procedure for clarity. Remove the cowl panel grille. Refer to: Cowl Panel Grille (501-02 Front End Body Panels) . NOTE: This step is only necessary when installing a new component...

Lincoln Nautilus 2018-2026 Service Manual: Specifications

Material Item Specification Fill Capacity Motorcraft® High Temperature Nickel Anti-Seize Lubricant XL-2 - Motorcraft® Wheel and Tire Cleaner ZC-37-A - General Specifications Item Specification Tire Inflation Tires See Safety Certi..

Replacing the Rear Wiper Blades

Lincoln Nautilus. Replacing the Rear Wiper Blades

Lift the wiper arm.

Note: Do not hold the wiper blade to lift the wiper arm.

Remove the wiper blade.