Lincoln Nautilus: Multifunction Electronic Modules / Factory Mode Deactivation. General Procedures
Deactivation
NOTE:
During vehicle build, some modules, such as the IPC and BCM module are set in factory mode.
Factory mode reduces the drain on the battery during longer periods
where the vehicle is not used. While in the factory mode, various
systems may be altered or disabled and the IPC
displays FACTORY MODE CONTACT DEALER in the message center. If the
vehicle is in factory mode, the system automatically reverts to
Transport mode after 60 ignition cycles. If the IPC displays TRANSPORT MODE CONTACT DEALER, refer to the Transport Mode Deactivation procedure in this section.
-
Place the ignition in the OFF position.
-
Verify the battery is fully charged.
Refer to: Battery Charging (414-01 Battery, Mounting and Cables, General Procedures).
-
Without push button start, cycle the ignition from off to on 60 times.
-
NOTE:
One IKT
must be in the vehicle.
With push button start, press the Engine Start/Stop button 120 times.
-
Refer to the Transport Mode Deactivation procedure in this section.
Refer to: Transport Mode Deactivation (419-10 Multifunction Electronic Modules, General Procedures).
DTC Chart: BCM
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation)...
Deactivation
NOTE:
After vehicle build, some vehicle modules are set in Transport mode
including the IPC and the BCM . Transport mode reduces battery drain
during longer periods where the vehicle is not used...
Other information:
Materials
Name
Specification
Motorcraft® Ultra-Clear Spray Glass CleanerZC-23
ESR-M14P5-A
Motorcraft® Rear Window Defroster RepairPM-11
WSB-M4J58-B
Motorcraft® Lacquer Touch-Up PaintPMPC-19500-XXXXA, PMPM-19500-XXXXG, PMPP-19500-XXXXA
ESR-M2P100-C
Repair
NOTE:
The antenna and heated window grid line material is not
embedded into the glass..
Materials
Name
Specification
Motorcraft® Disconnect Rear Drive Unit FluidXY-75W-QL
-
Check
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
Remove the RDU fluid filling plug.
If empty, fill the rear axle with clean R..