Lincoln Nautilus: Front Disc Brake / Front Brake Flexible Hose. Removal and Installation
Removal
NOTICE:
If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.
NOTE:
Removal steps in this procedure may contain installation details.
-
NOTICE:
Make sure that all openings are sealed.
Seal all the openings with clean blanking caps.
-
Remove the bolt and disconnect the front brake hose. Discard the washers.
Torque:
18 lb.ft (25 Nm)
-
-
Disconnect the brake tube fitting.
Torque:
159 lb.in (18 Nm)
-
Remove the bolt.
Torque:
22 lb.ft (30 Nm)
-
Remove the bolt and the front brake flexible hose.
Torque:
22 lb.ft (30 Nm)
Installation
-
To install, reverse the removal procedure.
-
Bleed the brake system.
Refer to: Brake System Pressure Bleeding (206-00 Brake System - General Information, General Procedures).
Special Tool(s) /
General Equipment
Brake Caliper Piston Retractor
Materials
Name
Specification
Motorcraft® Metal Brake Parts CleanerPM-4-A, PM-4-B, APM-4-C
-
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
Check
NOTE:
Road Force® values in illustrations are shown in pounds.
NOTE:
Match mounting is a technique used to reduce radial runout
or road force on wheel and tire assemblies. Excessive runout is a source
of ride quality complaints and match mounting can be used to minimize
the runout. Match mounting can be accomplished by changing the position
of the tire on the wheel.
NOTE:
P..
How Does Easy Entry and Exit Work
Easy entry and exit moves the driver seat
rearward up to 2 in (5 cm) and the steering
column up when you switch the ignition off.
The driver seat and steering column return
to their previous positions when you switch
the ignition on.
Note: Depending on your vehicle, the column
may move up and in.
Switching Easy Entry and Exit On and Off
Using the touchscre..