Lincoln Nautilus: Exterior Lighting / Front Turn Signal Lamp Bulb. Removal and Installation
Removal
-
Remove the front turn signal lamp bulb.
-
Disconnect the electrical connector.
-
Remove the bulb holder.
-
Remove the front turn signal lamp bulb.
Installation
-
To install, reverse the removal procedure.
Removal
Remove the front bumper cover.
Refer to: Front Bumper Cover (501-19)
.
Remove the front foglamp.
Disconnect the electrical connector...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the front bumper cover.
Refer to: Front Bumper Cover (501-19 Bumpers)
...
Other information:
Special Tool(s) /
General Equipment
Door Lift
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Open the door.
Remove the check arm bolt...
Removal
NOTICE:
If installing a new A/C compressor due to an internal failure of the
old unit, carry out the following procedures to remove contamination
from the A/C system. Failure to remove contamination from the A/C
system, if present, will result in poor A/C performance and/or damage to
the new A/C compressor and other components...
Categories
What Is Auto-Start-Stop
The system is designed to help reduce fuel
consumption and CO2 emissions by stopping
the engine when it is idling, for example at
traffic lights.
Auto-Start-Stop Precautions
WARNING: Apply the parking brake,
shift into park (P), switch the ignition off
and remove the key before you leave your
vehicle. Failure to follow this instruction
could result in personal injury or death.
WARNING: Apply the parking brake,
shift into park (P), switch the ignition off
and remove the key before you open the
hood or have any service or repair work
completed. If you do not switch the ignition
off, the engine could restart at any time.
Failure to follow this instruction could result
in personal injury or d
read more