Lincoln Nautilus: Exterior Lighting / Headlamp Leveling Sensor. Removal and Installation
Removal
Front suspension mounted
-
Remove the LH front wheel and tire assembly.
Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
-
Remove the LH fender splash shield.
Refer to: Fender Splash Shield (501-02 Front End Body Panels, Removal and Installation).
-
Remove the bolts and the front headlamp leveling sensor.
-
Remove the harness retainer.
-
Disconnect the electrical connector.
Torque:
177 lb.in (20 Nm)
Rear suspension mounted
-
Remove the LH rear wheel and tire assembly.
Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
-
Remove the rear headlamp leveling sensor.
-
Disconnect the electrical connector.
-
Remove the nuts.
Torque:
133 lb.in (15 Nm)
-
Remove the bolts.
Torque:
177 lb.in (20 Nm)
Installation
-
To install, reverse the removal procedure.
-
Calibrate the suspension height sensor. Connect the scan
tool and carry out the Ride Height Calibarion routine, following the
scan tool directions.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module...
Removal
Detach the clips and pivot the instrument panel LH lower trim panel downward.
Remove the headlamp switch...
Other information:
Overview
The
Lane Keeping System (LKS) has three options to help the driver stay
within their lane (lane keeping aid) and to provide lane keeping alert.
The Lane Keeping System (LKS) utilizes the camera located in the IPMA
to detect and track the road lane markings...
Identifying Fuse Types
Micro 2.
Micro 3.
Maxi.
Mini.
M Case.
J Case.
J Case Low Profile.
Slotted M Case.
Fuses – Troubleshooting
Fuses – Frequently Asked Questions
When do I need to check a fuse?
If electrical components in the vehicle
are not working...