Lincoln Nautilus: Exterior Lighting / Headlamp Leveling Module. Removal and Installation

Removal

1. NOTE: Removal steps in this procedure may contain installation details.

   NOTE: If installing a new module, it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new module after installation.

   Using a diagnostic scan tool, begin the PMI process for the Headlamp leveling module following the on-screen instructions
   

1. Remove the push pins, disconnect the electrical connector and remove the RH dash insulator panel.
   

1. 
   Remove the Headlamp leveling module.
   
   • Remove the Headlamp leveling module bracekt bolts and the Headlamp leveling module.
     Torque: 80 lb.in (9 Nm)
   • Disconnect the electrical connector.
     

Installation

1. To install, reverse the removal procedure.
   

1. Using a diagnostic scan tool, complete the PMI process for the Headlamp leveling module following the on-screen instructions.