Lincoln Nautilus: Steering Wheel and Column Electrical Components / Heated Steering Wheel Module (HSWM). Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. NOTE: This step is only necessary when installing a new component.

   NOTE: The PMI process must begin with the current HSWM installed. If the current HSWM does not respond to the diagnostic scan tool, the tool may prompt for As-Built Data as part of the repair.

   Using a diagnostic scan tool, begin the PMI process for the HSWM following the on-screen instructions.
   

1. Remove the driver knee airbag.
   Refer to: Driver Knee Airbag (501-20B Supplemental Restraint System, Removal and Installation).
   

1. Remove the steering column shrouds.
   Refer to: Steering Column Shrouds (501-05 Interior Trim and Ornamentation, Removal and Installation).
   

1. 1. Disconnect the HSWM electrical connector.
      
   2. Remove the HSWM mounting bolts and the HSWM .
      Torque: 80 lb.in (9 Nm)

Installation

1. To install, reverse the removal procedure.
   

1. NOTE: This step is only necessary when installing a new component.

   Using a diagnostic scan tool, complete the PMI process for the HSWM following the on-screen instructions.