Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new module, it is necessary to upload the
module configuration information to the scan tool prior to removing the
module. This information must be downloaded into the new module after
installation.
Using a diagnostic scan tool, begin the PMI process for the HVAC control module ..
Removal
Remove the LH loadspace interior trim panel.
Refer to: Loadspace Trim Panel (501-05)
.
Disconnect the rear lamp fade control module electrical connector.
Release the pin type retainers and remove the rear lamp fade control module.
Installation
To install, reverse the removal procedure.
..