Other information:
Removal
NOTE:
LH side shown, RH side similar.
NOTE:
Removal steps in this procedure may contain installation details.
Remove the pushpins and clip from the rear of the moulding.
Remove the pushpins at the front edge of the moulding.
NOTICE:
To avoid damage to the moulding, only use moderate force.
Using a n..
Removal
Remove the instrument panel.
Refer to: Instrument Panel (501-12)
.
Disconnect the electrical connector, remove the retainers and the air inlet door actuator.
Installation
To install, reverse the removal procedure.
..