Lincoln Nautilus: Instrument Panel and Console / Overhead Console. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
-
Insert trim tool in location(s) shown.
-
Rotate the tool 90 degrees to release the overhead console rear retainers.
-
Working from the rear to the front along each side release the overhead console retainers.
-
Rotate and remove the overhead console.
-
Disconnect the electrical connectors.
Installation
-
To install, reverse the removal procedure.
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
WARNING:
Before beginning any service procedure in this
manual, refer to health and safety warnings in section 100-00 General
Information...
Other information:
System Operation
System Diagram
Item
Description
1
IPC
2
BCM
3
IPC message center display
4
TPMS warning indicator
5
LH front TPMS sensor
6
RH front TPMS sensor
7
LH rear TPMS sensor
8
RH rear TPMS sensor
9
RTM
10
GWM
Network Message Chart
BCM
TPMS Network Inpu..
Bring the engine to normal operating temperature. Connect
the Vacuum/Pressure Tester to the intake manifold. Run the engine at the
specified idle speed.
The vacuum gauge should read between 51-74 kPa (15-22 in-Hg)
depending upon the engine condition and the altitude at which the test
is conducted. Subtract 4.0193 kPa (1 in-Hg) from the specified reading
for every 304.8 m (1,00..