Lincoln Nautilus: Body and Paint / Paint - General Information
Special Tool(s) /
General Equipment
Resistance Spotwelding Equipment
8 mm Drill Bit
MIG/MAG Welding Equipment
Spot Weld Drill Bit
Locking Pliers
Materials
Name
Specification
Seam SealerTA-2-B, 3M™ 08308, LORD Fusor® 803DTM
-
Removal
NOTE:
Left hand (LH) side shown, right hand (RH) side similar...
Materials
Name
Specification
Motorcraft® Acid NeutralizerZC-1-A
-
Motorcraft® Alkaline NeutralizerZC-2-A
-
Repair
NOTE:
Refinishing - Environmental Damage
WARNING:
Before beginning any service procedure in this
manual, refer to health and safety warnings in section 100-00 General
Information...
Other information:
If you switch the lane keeping system on, a
graphic with lane markings appears in the
information display.
When you switch the system off, the lane
marking graphics do not display.
Note: The overhead vehicle graphic may still
display if adaptive cruise control is enabled...
Removal
Remove the front turn signal lamp bulb.
Disconnect the electrical connector.
Remove the bulb holder.
Remove the front turn signal lamp bulb.
Installation
To install, reverse the removal procedure...
Categories
How Does Traction Control Work
If your vehicle begins to slide, the system
applies the brakes to individual wheels and,
when needed, reduces power at the same
time. If the wheels spin when accelerating
on slippery or loose surfaces, the system
reduces power in order to increase traction.
Switching Traction Control On and Off
WARNING: The stability and traction
control light illuminates steadily if the
system detects a failure. Make sure you
did not manually disable the traction
control system using the information
display controls or the switch. If the stability
control and traction control light is still
illuminating steadily, have the system
serviced by an authorized dealer
immediately. Operating your vehicle with
the traction co
read more