Lincoln Nautilus: Rear Seats / Power Fold Seat Control Switch. Removal and Installation
Special Tool(s) /
General Equipment
Removal
-
On both sides.
Using an interior trim tool, release the power fold seat control switch locking tabs.
Use the General Equipment: Interior Trim Remover
-
Disconnect the electrical connector and remove the power fold seat control switch.
Installation
-
To install, reverse the removal procedure.
Removal
On both sides.
Release the clips, the pin-type retainer and remove the floor console lower trim panel.
On both sides...
Removal
NOTE:
LH rear seat shown, RH rear seat similar.
NOTE:
Removal steps in this procedure may contain installation details.
Remove the rear seat backrest...
Other information:
Switching the Turn Signal Lamps On and Off
Push the lever up or down to
switch the turn signal lamps on.
Set the lever to the middle position to switch
the turn signal lamps off.
Note: Tap the lever up or down to make the
turn signal lamps flash three times...
System Operation
System Diagram
Item
Description
1
BCM
2
DDM
3
PDM
4
APIM
5
FDIM
6
GWM
7
RGTM
8
Door Ajar Switches
9
Headlamp Switch
10
Overhead Console
11
Overhead Console
12
Rear Courtesy Lamp
13
LH Rear Courtesy Lamp
14
RH Rear Courtesy Lamp
15
..
Categories
How Does Traction Control Work
If your vehicle begins to slide, the system
applies the brakes to individual wheels and,
when needed, reduces power at the same
time. If the wheels spin when accelerating
on slippery or loose surfaces, the system
reduces power in order to increase traction.
Switching Traction Control On and Off
WARNING: The stability and traction
control light illuminates steadily if the
system detects a failure. Make sure you
did not manually disable the traction
control system using the information
display controls or the switch. If the stability
control and traction control light is still
illuminating steadily, have the system
serviced by an authorized dealer
immediately. Operating your vehicle with
the traction co
read more