Lincoln Nautilus: Rear Seats / Heated Rear Seat Switch. Removal and Installation
Removal
-
On both sides.
Release the clips, the pin-type retainer and remove the floor console lower trim panel.
 |
-
On both sides.
Release the clips and remove the floor console middle trim panel.
 |
-
Remove the floor console rear trim panel.
-
On both sides.
Remove the screws.
-
On both sides.
Release the spring retainer.
-
Disconnect the electrical connector(s).
-
On both sides.
 |
-
Release the locking tabs and remove the heated rear seat switch.
.jpg) |
Installation
-
To install, reverse the removal procedure.
Heated Rear Seat Module. Removal and Installation
Removal
Remove the rear seat cushion.
Refer to: Rear Seat Cushion (501-10B Rear Seats, Removal and Installation).
Release the seat cushion cover J-clips...
Power Fold Seat Control Switch. Removal and Installation
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
On both sides.
Using an interior trim tool, release the power fold seat control switch locking tabs...
Other information:
Lincoln Nautilus 2018-2026 Service Manual: Front Seatbelt Retractor and Pretensioner. Removal and Installation
Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: RH shown, LH similar. Depower the SRS . Refer to: Supplemental Restraint System (SRS) Depowering (501-20 Supplemental Restraint System) . Remove the B-pillar trim panel...
Lincoln Nautilus 2018-2026 Service Manual: Battery and Battery Charging Health and Safety Precautions. Description and Operation
WARNING: Batteries contain sulfuric acid and produce explosive gases. Work in a well-ventilated area. Do not allow the battery to come in contact with flames, sparks or burning substances. Avoid contact with skin, eyes or clothing. Shield eyes when working near the battery to protect against possible splashing of acid solution...
Categories
- Manuals Home
- 1st Generation Nautilus Owners Manual
- 1st Generation Nautilus Service Manual
- Massage Seats
- Replacing the Rear Wiper Blades
- Drive Mode Control
- New on site
- Most important about car
Changing a Flat Tire
WARNING: If the tire pressure monitor sensor becomes damaged it may not function.
Note: The use of tire sealant may damage your tire pressure monitoring system and should only be used in roadside emergencies. If you must use a sealant, use the Tire Mobility Kit sealant. Replace the tire pressure monitoring system sensor and valve stem on the wheel by an authorized dealer after use of the sealant.
Note: The tire pressure monitoring system indicator light will illuminate when the spare tire is in use. To restore the full function of the monitoring system, all road wheels equipped with tire pressure monitoring sensors must be mounted on the vehicle.
If you get a flat tire while driving, do not apply the brake hea
