Lincoln Nautilus: Exterior Lighting / Rear Lamp Assembly. Removal and Installation
Removal
NOTE:
This procedure can be used for all locations of the component.
-
Remove the screw cover.
-
Remove the screw and position the rear lamp assembly.
-
Disconnect the electrical connector and remove the rear lamp assembly.
Installation
-
To install, reverse the removal procedure.
Removal
Using a non-marring tool release the light sensor and position it up.
Disconnect and remove the light sensor...
Removal
Remove the LH loadspace interior trim panel.
Refer to: Loadspace Trim Panel (501-05)
.
Disconnect the rear lamp fade control module electrical connector...
Other information:
System Operation
System Diagram - Memory Seat
Item
Description
1
Memory Power Seat Motors
2
HS1-CAN
3
PCM
4
HS1-CAN
5
Ignition Switch
6
GWM
7
Memory SET Switch
8
MS-CAN
9
DSM
10
MS-CAN
11
DDM
12
Position Sensors
13
Motors
14
LIN
15
With Multi-Contour Seats
16
Driver Seat Control Swi..
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Release the retainers and remove the RH lower floor console trim panel.
Use the General Equipment: Interior Trim Remover
Release the retainers and remove the LH lower floor console trim panel.
Use the ..
Categories
What Is Auto-Start-Stop
The system is designed to help reduce fuel
consumption and CO2 emissions by stopping
the engine when it is idling, for example at
traffic lights.
Auto-Start-Stop Precautions
WARNING: Apply the parking brake,
shift into park (P), switch the ignition off
and remove the key before you leave your
vehicle. Failure to follow this instruction
could result in personal injury or death.
WARNING: Apply the parking brake,
shift into park (P), switch the ignition off
and remove the key before you open the
hood or have any service or repair work
completed. If you do not switch the ignition
off, the engine could restart at any time.
Failure to follow this instruction could result
in personal injury or d
read more