Lincoln Nautilus: Rear Seats / Rear Seat Armrest. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the inboard child safety seat tether anchor bezel.
-
Release the backrest lower J-clip. Unzip the inboard backrest cover and remove the armrest fasteners.
Torque:
80 lb.in (9.0 Nm)
-
Lower the armrest and release the armrest back panel upper locking clips from the backrest frame.
-
Detach the backrest cover from the armrest hooks. Detach the J-clip and remove the armrest.
Installation
-
To install, reverse the removal procedure.
Special Tool(s) /
General Equipment
Flat Headed Screw Driver
Removal
NOTE:
LH rear seat shown, RH rear similar.
NOTE:
Typical head restraint guide sleeve shown, others similar...
Removal
WARNING:
The following procedure describes critical repair steps
required for correct seat component installation. Follow all notes and
steps carefully...
Other information:
Filling
Refer to the Refrigerant Oil Adding (when new components
are installed) chart below for refrigerant oil adding amounts and
methods of installation.
For the correct Refrigerant Management Center special tool,
Refer to: Climate Control Tools and Equipment (412-00 Climate Control System - General Information, General Procedures)...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module. This information must be downloaded into the new
module after installation...